Science and Automatic

Automatic mode refers to the aging system in the pre-VSR input scan curve procedure automatically select parameters and decided to aging time, the limitation before the end of the operator can not interfere with the system, it can not adjust the parameters of a function.  Most of them were obtained in the natural frequency scanning to find a natural frequency of the value of the lowest natural frequency of the limitation in its vicinity, or to find a peak of high natural frequency, timeliness in its vicinity, or the natural frequency of all the scans have limitations.  This analytical work, the specific stress conditions are not fully automated approach might lead to leakage of timeliness, wrong prescription and arbitrary limitation.

 For large quantities of a certain kind of artifact, in its optimum vibration worked out pre-conditions and a number of effective frequency, amplitude height, aging time, the effect evaluation method, scanning frequency parameters can be credited to the host and its parameters No, after the number of automatic processes can be automated under the conditions of the preparation to deal with the kinds of artifacts, this automatic process is scientific and practical.  Can store and perform the functions of this process is called science and automatic. It may not be the frequency limitation of the peak value of the lowest natural frequency, it may not correspond to the highest natural frequency of the peak acceleration.  Been an effective treatment may be only one natural frequency, it could be two or more.

 Scientific automatic also has the following functions:
 A, working speed range can be predetermined;
 B, automatic on-line printing of various stages of aging, on-line identification of all parameters, Needless to stop and then output;
 C, dynamic aging multiple peaks, automatic tracking natural frequency of change;
 D, identify the working speed range of automatic monitoring of all the resonance peaks (harmonics can be said that the spectrum can be approximate), and then optimize the aging process;
 E, S-line automatic processing of various materials within the workpiece;
 F, automatic monitoring and online printing aging results;
 G, auto-complete dynamic limitation, steady rate, fixed rate, fixed speed and other technology;
 H, Sweep and aging can be automated or eliminated.

 Readers recommend that users refer to the following concepts:
 Automatic VSR, scientific automatic, modal analysis, science and automatic aging